Close

1999 Volkswagen Passat Recalls

Get the latest 1999 Volkswagen Passat recall updates.

Most Recent 1999 Volkswagen Passat Recall

On June 13, 2008, Volkswagen recalled 412,000 Volkswagen Passat. Volkswagen is recalling 412,000 my 1999-2005 passat (5th generation) vehicles equipped with automatic transmissions and produced after june 14, 1999. these vehicles may have an underbody heat shield that can become damaged. in addition, affected vehicles with automatic or manual transmissions may have a fuel line (1.8t engines only) or fuel tank ventilation valve (4motion/all wheel drive only) that can leak due to fracture.
Not your car? Find your recalls now:

1999 Volkswagen Passat Recall Details

RepairPal Expert Overview on June 13, 2008
Volkswagen is recalling 412,000 my 1999-2005 passat (5th generation) vehicles equipped with automatic transmissions and produced after june 14, 1999. these vehicles may have an underbody heat shield that can become damaged. in addition, affected vehicles with automatic or manual transmissions may have a fuel line (1.8t engines only) or fuel tank ventilation valve (4motion/all wheel drive only) that can leak due to fracture.
RepairPal Expert Overview on June 13, 2003
On some passenger vehicles, the fuel tank filler neck can suffer abrasion damage if the rear tire goes flat and the vehicle is driven until the tire disintegrates.
Summary on February 5, 2001
Vehicle description: passenger vehicles. the tie rods of the steering assembly are protected on each side by a seal to prevent moisture and dust particles from entering the swivel bearing mechanism. it is possible that some tie rod seals may not seal properly.
Summary on October 9, 1999
Vehicle description: passenger vehicles equipped with automatic transmissions. a control valve in the vacuum hose connecting the brake booster to the intake manifold may not open or close fully at temperatures below -4 f under certain driving conditions.
Summary on October 5, 1999
Vehicle description: passenger vehicles. the tie rods of the steering assembly are protected on each side by a seal to prevent moisture and dust particles from entering the swivel bearing mechanism. it is possible that some tie rod seals may not seal properly.
Get notified about future recalls
×
Page 1 Created with Sketch.
You're Signed Up!
We will notify you of any recalls that affect your
Close