Close

BobbyRobby

Journeyman 557e801cd4784d8ff835b38f3ce0382fce2b6648a740d3c63b0eb4abb5a716fbJourneyman
844 points
Recent Activity

No activities found
Question Answered: Where is the "body codes" or "sales codes" located?
March 27, 2017, 02:44 PM
Should be somewhere on top of the radiator support or "radiator closure panel" toward the driver's side of the vehicle.
Question Answered: how to replace the harmonic balancer.and which way does the bolt turn.
March 27, 2017, 02:40 PM
Before you even get that far (or even if you have) do you have the correct puller and installer for the balancer? There's a specific tool needed to remove and install it correctly.
Question Answered: I've changed the alternator and fuel pump still won't run, what could it be?
March 27, 2017, 02:37 PM
For something like that you'll want to contact a local shop for a no-start diagnosis. Sometimes people get lucky installing parts until it's fixed, but that gets more expensive very quickly. Talk to a local professional! http://repairpal.com/hyundai-within-10-miles-of-greenville-texas-75402
Question Answered: Turn over but won't hit spray starting fuild and it hit but won't start
March 27, 2017, 02:37 PM
For something like that you'll want to contact a local shop for a no-start diagnosis. Sometimes people get lucky installing parts until it's fixed, but that gets more expensive very quickly. Talk to a local professional! http://repairpal.com/chevrolet-within-10-miles-of-booneville-mississippi-38829
Question Answered: front brakes are working, rear brakes are not
March 27, 2017, 02:27 PM
Is there a reason the car is being lifted off the ground? Check the brake fluid level. If you're able, you can also try bleeding the brakes to see if you're even getting fluid to the rear brakes. While you're back there, you can also check the condition of the calipers/brackets/sliders for any damage or corrosion.
Question Answered: where is the fuel pump located
March 27, 2017, 02:25 PM
You need to drop the fuel tank (after draining it) in order to access the fuel pump. The fuel pump is installed on the top of the fuel tank.
Question Answered: I spilt soda all over the middle console 10 min. later the heater went crazy?
March 27, 2017, 02:18 PM
You may have shorted something out with all of that liquid getting into and onto electrical components. Try contacting a local shop to get a diagnosis of the extent of damage.
Question Answered: Evap leak code p0455
March 27, 2017, 02:15 PM
If the gas cap has already been replaced but the code came back, you'll want to get the evap system tested. Call around to local shops (link below) to inquire for a smoke test, this is the best way to find a leak in the evap system. Otherwise you may end up replacing random parts at greater cost! http://repairpal.com/saab-within-10-miles-of-spokane-washington-99212
Question Answered: ran can into some water, dealer said motor locked, i brought car home chareged
March 27, 2017, 02:10 PM
If the dealer said the motor was hydrolocked there isn't much you can do. Typically when trying to start a locked motor, major internal parts get bent. With the battery disconnected, you could put a ratchet on the front bolt and try to turn the motor by hand to see if it's something else. If the motor is still seized, you'll need a new one.
Question Answered: My hummer is making a chirping noise under the hood
March 27, 2017, 01:37 PM
Check the serpentine belt and serpentine belt tensioner!
Problem Reported: Limited Slip Axle may Vibrate, Bind, or Judder in low speed turns
September 24, 2015, 11:42 AM
<p>New TSB may be available</p> <p>&nbsp;</p> <p>According to Ford Bulletin 06-04-04</p> <p>Some 2003 + INDEPENDENT REAR SUSPENSION (IRS) AXLE F-150 vehicles equipped with a 9.75&Prime; or 8.8&Prime; limited and Mustang vehicles equipped with &nbsp;limited slip rear axle, may exhibit a chatter, shudder, a binding sensation, or a vibration during low speed turns. On 4X4 vehicles, the sensation may appear to be originating from the front axle or the steering gear.</p> <p>First verify the condition. On 4X4 trucks ensure that Modifier (XL-3) for fifteen (15) minutes prior to the vehicle is in 2WD, to isolate the rear axle. If the condition is verified to be in the rear axle, replace the limited slip clutch pack.</p>
No activities found
No activities found