Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Transmission goes into gear but will not drive only reverse

(1999 Lincoln Navigator)
in Saint Petersburg, FL on October 02, 2012
truck was driving fine. Started truck put into drive and would not move. Moves in reverse fine.
Displaying 1 answers & 4 comments
Popular Answer
on October 03, 2012
WILL IT MOVE IF PUT IN LOW GEAR? ( SHIFTR ALL THE WAY DOWN) AND IS REVERSE WHERE IT SHOULD BE AS FAR AS GEAR INDICATOR?
on October 03, 2012
The gear indicator has not been right for about 2 years. Park is neutral....etc....Transmission goes into all gears moves in reverse with no problem but will not mover in 1st, 2nd or 3rd forward gears.
on October 03, 2012
sounds like you need a transmission
on October 03, 2012
ugggggghhhhhh......was hoping linkage or a sensor or module
on October 03, 2012
I AGREE WITH GOODGUY. BUT WE CAN ONLY SPECULATE WHAT THE PROBLEM IS.
YOU NEED SOMEONE TO "LOOK" AT THIS FOR YOU. SEEMS LIKE IT SHOULD MOVE
IN LOW IF IT MOVES IN REV. AS I THINK IT USES THE SAME CLUTCH PACK FOR BOTH.
BUT THEN AGAIN JUST A GUESS. GOOD LUCK!
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Replaced the engine now the transmission is not...
I recently replaced the engine. now the car won't move. it starts and engine runs but when trying to get the car to g...
My gear shift lever is 'loose'. It wiggles bac...
checked the brake shift lock actuator and it's fine. put it all back together and the gear shift lever is 'loose'. ...
Didn't find what you were looking for?