Car Questions
RepairPal is your advocate for car care advice and guidance


(1990 Chevrolet S10)
in Grove City, OH on February 28, 2010
how to remove drive shaft on an s-10 chevy dorango
Ask a Question
Displaying 2 answers & 0 comments
Popular Answer
It is a relatively simple job to replace the drive shaft and does not require many tools or high skill level. Make sure the vehicle is properly supported and cannot move while you are carrying out this repair. Autozone have some popular workshop manuals for free on line once you register (for free) on their website .There is a company that independent auto repair shops "buy" their information from that offer a very reasonable service to do it yourselvers. You get a one year subscription to year make and model specific repair procedures, service bulletins, component locations, wiring diagrams ect.... great quality information same as the professionals have ,much better than generic workshop manuals from parts stores, much cheaper than the factory manual. or try and get an online repair manual subscription.
Sign in to reply
on May 01, 2010
There are four bolts, two bolts in one of two clamps on the back side of the rear end where the rear u joint is. remove the 4 bolts and free the drive shift then side the drive shift out backwards don't let the drive line or shift hit the ground. The slip yoke will slide out of tail of your transmission do not let your slip yoke hit the ground. It is also a good ideal to wrap electrical tape around the exposed u joint caps so they don't fall off and damage the cap barrings.
Sign in to reply
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
My ml has cut out twice in the past six months when we punched it to pass. it was like nothing was there. i took it...
I have been told if i tune it to the extra 154 hp and 350 lbs of torque will blow my training or rear end end is this...
Didn't find what you were looking for?