Close

1996 Toyota Tacoma Questions

Get answers to your auto repair and car questions. Ask a mechanic for help and get back on the road.

Find questions for your car.
The compressor never cycles before burning the fuse. I installed a new compressor, dryer, etc.. Please tell me which part I need to replace to correct this problem.
Thanks!
New clutch, pressure plate throw out bearing etc..
It never did this until my old ladys brother fixed the steering stablizer,cause?
replaced fuses, and head lamp bulbs
This is the second ball joint failure for this truck in 3 years...I have approx. 238,000 miles on it now....Both times have happened while driving...the one tonight at highway speed....Thankfully was able to get it out of traffic...no injuries...just to the truck...Any recalls for this?
new plugs,distributar,o2 sensors,egr cleaned,mass air cleaned,
I would lik to replace the heater control valve on my 1996 toyota tacoma and am not sure where to start looking for it?
blew the fuel system out with air,got the truck to run for 3 days,put seafoam in tank now it will not stars
what could it be? theres many things ive looked up and i dont want to spend thousands on a bunch of different things if they fix the wrong thing. also, check engine light is always on. but truck seems to run great! but when turned off and i get out it sometimes makes a humming sound for a little bit. (fault code P0125, catalyst:notready oxygen sensor:notready evap system:notready)
1996 toyota tacoma, 4 wheel drive, 2.7 engine, when cold the engine starts perfect, but when you shut id down, it will start back immediately, but if you let it set for 15 or 20 minutes it want start, i put a new fuel pump on it about 3 years ago, i put a different distributor shaft with coil on it, a new distributor cap, a new roller button, new wiring, new plugs, different EGR valve, took throttle body off and cleaned good and put new gaskets on that, a cold water sensor behind the engine, its broke me up, dont know what to do now, please help me if you can, THANKS
WHAT VOLTAGE SHOULD I HAVE
the ignition switch was left on over night.next morning we charge the battery and now the truck will not start.before the key was left on the truck ran great
having a misfire problem scanner will show all cylinders misfiring at times the faster the engine runs the worst it gets but idles great and starts good hot or cold also gets fair gas mileage 193000 miles
Turn the key and everything lights up but the start is dead. after a few more tries it starts. Replaced the ignition switch, no help.
Get an estimate and never overpay again
RepairPal guarantees your repair will be done right.