The engine mount on the passenger side of the car can wear out on cars with high mileage. This will put extra stress on the other mounts and the faulty mount will need to be replaced.
Problems for specific Toyota Corolla years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 1992 Toyota Corolla problems
The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.
The ignition coil inside the distributor may fail. Our technicians tell us this may result in a hesitation on acceleration, especially when the vehicle is warming up on cold, rainy days. The pickup coils inside the distributor can also fail and cause a no-start condition. There have also been some failures of the radio noise suppressors inside the distributors, which can short out. Our technicians recommend replacing the whole distributor with a complete, genuine Toyota distributor if any of its components fail.
If the vehicle develops an annoying, clunking sound when driving over bumps it is usually the struts and strut bearing plates. These may need replacing at 100,000-125,000 miles or sooner. If the noise is a more of a squeak or groan, it can be usually be eliminated by spraying a light lubricant on the suspension bushings 1-2 times per year.
At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes.
A loss of power on the freeway may due to an internally leaking fuel pulsation dampener. This commonly occurs on higher mileage vehicles.
Some of the fuel/temperature gauges fail and read maximum at all times. Our technicians tell us that there is a gauge cluster replacement that includes the little voltage regulator as well.
The Throttle Position Sensor can get out of adjustment due to wear in the throttle body or due to carbon build up. This will cause the idle timing to advance more than 30 degrees which will cause very high HC and NOx emissions. Conversely, the Throttle Position Sensors can wear out and not properly advance the timing which causes a lack of power and poor fuel economy.
On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.
Usually by 150,000 miles the AC system will need some attention, especially in climates where it is used often. Our technicians tell us that it is best to service the AC system every 2-3 years. This keeps the moisture in the system at a minimum which extends the life of the components.