Close
Car Questions
RepairPal is your advocate for car care advice and guidance

The controls to direct the air flow from floor-to-defrost does not work.

(2003 Hyundai Elantra)
in Telford, PA on March 12, 2012
I pulled the dash front and removed the control device, took it apart, cleaned the brass contacts but no luck. Any advice before I buy a new control? Anyone else have this problem?
Displaying 1 answers & 2 comments
Popular Answer
of Greg's Orange Auto on March 12, 2012
this could be a blend door issue not the controller. you might seek diag b4 you waste time and money on it
on March 12, 2012
thanks for the reply! I'll post again once i get it solved.
on October 22, 2012
did you ever figure it out? ive got the same problem and cannot pass state inspection until it is fixed. repair shop is saying about $800 for parts & labor.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Why is it when my gas tank is about half full the engine will cut out. It runs great and no check engine light no co...
After the car cranks, it is rough putting the car into driver or reverse. For the first 3 miles the car transmission...
Didn't find what you were looking for?