Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Service 4wd message replaced encoder ring and TCCM and still not working.

(2004 GMC Sierra 1500)
in Stow, OH on February 10, 2015
When I turn the key on the ON position the lights on the 4wd selector switch the buttons come ON then go OFF. Then the SERVICE 4WD light comes on. None of the buttons responded. I have another 04 gmc sierra 4wd I took the tccm and put it in and still the same lights come ON when turn the key on then go out and no response when I push the buttons. I replaced the encoder ring and same thing. I swapped out the 4wd selector switch and still nothing the only thing i haven't tried is replacing the transfer-case shift motor or the front axle actuator. I also cleaned the grounds on the frame that are underneath the driver door. i went to a couple shops and they want $150 - $200 just to hook up the scanner and diagnose the problem.
Ask a Question
Displaying 1 answer & 0 comments
Popular Answer
of Gearheads Auto Service on February 10, 2015
I recommend you get someone to scan the system and see what is actually going on. Our basic diagnostic charge for the 4wd is $69+tax. We can check next week, if you want.
Sign in to reply
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
The lights on the transfer case selector switch in the dash no longer comes on. it does flash when turning the key to...
Didn't find what you were looking for?