Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Sensors

(1999 Oldsmobile Intrigue)
in Cleveland, OH on March 31, 2009
the anti brake,trac off & service vehicle soon light is on,the oil has been changed, the brakes replaced, how can i get the lights off
Displaying 4 answers & 0 comments
Popular Answer
on March 31, 2009
There are fault codes stored in the systems. A scan tool is necessary to read the fault codes. The codes will help diagnose and isolate the cause of your warning lights comming on. I would suspect and ABS system fault is causing all three lights to come on, one of the wheel speed sensors maybe.
on October 27, 2009
The problem is not your speed wheel sensor. I had the same problem and it is your ABS Control Module which is bad. Online there is a company that will repair it for about 75.00 with five year warranty. Module Master if you google the name. If the ABS gears are acting up you will also want to change your brake fluid
on April 12, 2010
I had the same issue. My wiring was frayed. Any faying of the low voltage wire will cause a slight "interruption" in the signal going back to the computer which is what caused all of my lights you described to come on. Once my wiring was repaired properly the lights went off...never to return. This was repaired 1.5 years ago. The wires were frayed near the wheel.
on October 27, 2009
Carreem is correct that the ABS module could also cause this fault and the modules are rebuildable. You cannot assume however that just because the ABS light is on that the module is faulty. Fault codes MUST be read and DIAGNOSED before parts are determined faulty and replaced.
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
replaced spark plugs, coils, valve cover gasket...
Purchased a used car for my daughter. car sputters obd code present was misfire #1 & 2. replaced battery, radiato...
Should I be getting a signal from the ECM to th...
Have a code 0102 mass air flow sensor. just wanted to know if i should be getting a signal from the ecm to the mass a...
Didn't find what you were looking for?