Car Questions
RepairPal is your advocate for car care advice and guidance

Replaced plugs and boots on my squad car and still chugging and no power whengas

(1999 Ford Crown Victoria)
in Rockwell City, IA on September 13, 2013
When I try to gun it it chuggs like its missfiring even though all plugs were changed and boots like shop said what could be wrong???
Displaying 2 answers & 5 comments
Popular Answer
on September 14, 2013
Also check for ignition coil(s) causing misfire. Good scanner can run a cylinder contribution test to find the weak cylinder(s)..
Now, when you say boots, do you mean all 8 coils w/boots and new plugs were installed, or just new plugs and boots only?
Sign in to reply
on September 14, 2013
New plugs and boots only.. had it scanned before I put them on and only said 4and 5 were misfiring needing new plugs and boots
on September 14, 2013
Tell you what is the BEST thing to do, replace ALL 8 coils and be done wit it! I have just replaced the misfiring coils before, then have to go back and do the same thing for the others soon after. THIS WILL FIX YOUR PROBLEM! Let us know how it turns out.
on September 17, 2013
My dad was saying it could be my tps sensor too
on September 17, 2013
Nope, dont think so!
on September 14, 2013
scan test for codes and check fuel pressure
Sign in to reply
on September 14, 2013
Runs great idle and reving it up it only happens in drive the chugging.
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
i have a 1997 ford crown victoria there’s two different size brake pads that i can purchase for this vehicle will be...
I disconnect the battery cables because i don’t drive this car very often now i have to get it smog do i have to rese...
Didn't find what you were looking for?