Close
Car Questions
RepairPal is your advocate for car care advice and guidance

REPLACED CLUTCH, MASTER, SLAVE,CAN ONLY GET PRESURE 3\4 THE WAY IN PEDAL

(1990 Isuzu Trooper)
in Ferris, TX on February 01, 2012
WONT DISINGAGE CLUTCH FULLY, WONT START IN GEAR WITH PEDAL PUSHED DOWN, NOT LEAKING FLUID, GO DOWN THE ROAD CLUTCH STILL CATCHING A LITTLE BIT JUST ANOUGH TO KEEP U MOVING, STALLS AT STOPS
Displaying 1 answer & 0 comments
Popular Answer
on February 01, 2012
Not knowing why you originally replaced all that stuff, I can give you a best guess. On the rod that sticks out of the back of the clutch master cylinder, there is usually a threaded portion with a lock nut on it. If so, loosen the lock nut and "unscrew" the rod a few turns and tighten lock nut. If the pedal is better, but not good enough, repeat the process. When you have the clutch working as it should, wiggle the clutch pedal. You should have a little "free play" between the rod and the master cylinder. If you don't have the freepaly, shorten the rod a little bit until you do have the needed freeplay. If you leave it too tight, the clutch will wear prematurely.
Sign in to reply
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Going up hill and it slipped and would not shift in to 2nd or third or 4th changed transmission did same thing put an...
92 isuzu trroper had a bad fuel pump. relaced it. got it running for about 30 seconds and then it died. checked the f...
Didn't find what you were looking for?