Close

Car Recalls

Get details and alerts on all automotive recalls.

Does your car have a recall?
Summary on June 11, 1990
Plastic fuel gauge mounting nut may crack and allow fuel to leak from the fuel tank.
Summary on May 21, 1990
Electronically controlled valves in the cruise control actuator may not function properly due to dirt entering the valves.
Summary on May 21, 1990
Plastic fuel filter assemblies may develop leaks.
RepairPal Expert Overview on May 9, 1990
If sunroof glass is removed and reinstalled by vehicle operator, hinge assemblies can be accidentally improperly mated.
Summary on May 8, 1990
Improperly torqued tie rod clamp fasteners could allow the tie rod to loosen and eventually separate.
Summary on May 4, 1990
Air bag inflator case was incorrectly machined.
Summary on April 30, 1990
Operation of sunroof in "non-standard" manner may cause male hinge disengagement from the roof hinge receiver.
RepairPal Expert Overview on April 25, 1990

The air bags may not deploy to protect occupants in an accident. This would result in increased risk of occupant injury.

Recalls on your Dodge or Chrysler must be performed by a Dodge or Chrysler dealership. Chrysler notified known owners of affected vehicles in 1990. If you did not receive a notification, but wish to check to see if your vehicle is included, please contact one of your local Dodge or Chrysler dealerships. They will also check for any other uncompleted recalls on your vehicle. For best results, be prepared to provide your Vehicle Identification Number (VIN) to the service department consultant you speak with.

Summary on April 19, 1990
Owner's manuals were printed with rear center seat belt information omitted.
Summary on April 18, 1990
Improperly torqued connections of front fuel feed and return hoses to fuel pipes at the body rail could loosen and leak fuel into the underhood area.
Summary on April 6, 1990
Improperly manufactured steering lock bolts could break if driver applies excessive force to a locked steering wheel in an attempt to disengage the steering lock.
RepairPal Expert Overview on March 22, 1990
Power steering pump bracket is subject to breakage due to excessive tension caused by a lack of clearance between the pump mounting bracket and sealing flange edge of the oil pan.
Summary on March 19, 1990
Lock washer located under the nut that secures the front hub to the drive shaft may have had improper heat treatment and could crack.
Summary on March 12, 1990
Misaligned rear seat safety belt shoulder retractor assemblies could cause pendulum interference, causing the belt to remain in locked position or to travel freely without locking.
Summary on March 9, 1990
Battery to starter cables are longer than specified; excessive cable length could contact engine damper pulley.
Get notified about future recalls
×
Created with Sketch.
You're Signed Up!
We will notify you of any recalls that affect your
Close