Close

Pontiac Grand Am Questions

Get answers to questions about your Pontiac Grand Am at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
1,211
questions

When I 2004 Pontiac Grand Am key will not turn all steps to try remove lock cylinder will not work. Already ordered replacement parts if key will not turn is it possible to remove in tire assembly with ignition lock cylinder still inside of ignition switch does it require to remove the wires to turn the key. I know to remove the cylinder itself you must turn the key which is why I bought the total assembly with cylinder. Have not attempted to remove.

Car for e fine yesterday. Got in to go to work and it pulls the theft system again. Done it once before. Put a new passcode in. Passcode.didnt work this time. Just want to not have it at all. I have remote.start, does that have a thing to do with this issue?

My check engine light came on it said air mass flow sensor

My runs for a couple of days when I turn off it want crank but later it will crank

I replace my starter cause when I try starting it the car be wanting to start it just make a click sound

After I did and cut it off it want crank back up had starter replaced

Looks like anti freeze or is it defrosting

Trouble shooting code PO442 locating purge valve canister

first time it did this was today.

Alternating intermittent problems with shifter not releasing from Park and with ignition cylinder not turning all the way back. The wires seemed okay at the shifter but I need to know where the solenoid is located

I displace to crank sensor and cam sensor that's what AutoZone said

what would make my car start shifting hard, and cutting out, after the fuses under hood, were messed with?

i start the car, the alarm sounds for about 30 seconds and stops for about 10 seconds and starts up again.

I accidentally bought 2004 wires and plugs, instead of 2002 like I needed. Is it okay to use the ones I bought or should I go get the right year? Could it cause problems if I don't switch them out?

Already changed the wheel hub

My light on cruise control doesn't work .it won't go into cruise control.

I hear a rubbing sound every time i hit my brakes all the way down or even sometimes when i turn and don't even use my brakes.

Need answer ASAP

It looses most all horsepower staggers Rough idle won't be able to get above 800rpm missing

We can change it to vent and floor but it will not blow out of the defrost. We bought an actuator to replace the bad one. We found the temperature actuator but cannot locate the one to change where the air comes out from.

Car was fine and quiet pulling out of my driveway. Turned corner and stepped on gas and it sounded like my muffler fell off. Couldn't even accelerate

Won't go into overdrive button doesn't seem to do anything why would button not work for over drive?

2003 Pontiac grand am key that have used for awhile won't turn inside ignition switch my car won't start because of this naturally what is this

Same key that's been starting car fits like normal in ignition switch but won't turn switch on or allow car to start . Never happened before. Checked all ignition switch fuses they are fine

none of the control panel gauges light up when key is in the daytime running headlights flicker on and off and the only light on control panel that flickers on and off is the check engine light I try to start the car but it won't kick over it sounds like it wants too but it doesnt

Replaced battery and alternator. Thought problem was fixed. Drove the car about 60 miles. Battery light came on, air bag light came on, fuel light came on and fuel gauge went to empty. All dash lights lit up and car sputtered and died. Don't know what to do!!

I just baught the car,drove it home ,parked it ,cleaned it up,put a little talc in it ,then decided to drive around the block ..it shifted to drive ,but rolled forward almost to a stop on its on like it would in park and wouldn't pull ,3rd ..cant feel a shift into gear,then 2nd gear works fine,along with park,reverse,and neutral...could it just be the linkage ,or shift cables ?

I just drove the car almost 40 miles ...transmission acted fine ,then second day after sitting still...i go to shift into drive ,you could feel drive go into hear ,but rolls forward ,then almost to a stop on its on like it went into park.3rd doesn't feel a gear ,but will take off in 2nd gear...i just simply didn't try to drive it down the street ,to manually try and see if it would shift..i parked it instead...so I need to know ,what should I do ?

Was driving my car home turned into driveway and it's shut itself off and will not start back..as I turned in the security light came on and stayed on it never blinked or anything ...we put ignition and manifold in it and it's still not working plz help

occurs when engine hot, not cold. I can finesse throttle to increase rpms. New fuel pump 4 months ago.