Close

Nissan Frontier Questions

Get answers to your auto repair and car questions. Ask a mechanic for help and get back on the road.

Find questions for your car.
566
questions
Just brought this car and just trying to see which one it take.
All lites on dash lite up with key on on position. These include seat belt, service soon, oil, and battery. I replaced 4 bad bulbs on the specs cluster and the air bag or srs lite still does not come on. Is it suppossed to lite up with key on on position. 2000 Nissan Frontier, 4 cylinder, standard.
I have a 2002 Nissan Frontier with 3.3L V6 SUPERCHARGED engine that just
died... can I replace with a NON-supercharged engine? or where can I find the proper replacement engine.
NOT finding anything supercharged; mechanic told me that I cannot just use a "regular" engine to replace???
Please help!!!
Thanks,
~Concetta
PS I know nothing about vehicles!
Pulled the transmission to repair a rear main seal. Replace the seal and reinstalled the transmission. 2 wires on the transmission range sensor came loose. I purchased a new sensor and installed it. Now the transmission won’t shift from 2 to 3rd gear. Any idea what might be the problem.
Thanks in advance
Tom
outside temperature in 90's, engine kept running fine...just no speedometer readings as well as no rpm and engine temp. lights worked but AC was erratic...seemed to clutch in and out. 2000 Nissan frontier 4x4 crew cab.
It will happen then clear up and idle smooth for few minutes then do it again it only lasts for maybe 5-10 seconds
2004 Nissan Frontier 3.3LSOHC engine, automatic transmission, 4wd 76K miles. I have a lengthy written problem / repair attempts background and lengthy list of related detailed questions, These are too large to cut and paste here. I there a alternate means to send this background info and detailed question list to you for evaluation and if found acceptable rough answer and advice cost estimating ?
It died on me when turning. The negative battery cable wasn’t loose . I tightened it and it would turn over but not start. I replaced the crankshaft sensor. And nothing . I sprayed starter fluid just a dab and it started but idled rough and immediately shut off. I hooked up code diagnostic tool to it and it read error. I’ve checked all fuses and relays I could find and still no luck .
What it might be and why does the diagnostic tool show error ?
I could not remember if the shaft o-ring needed light grease or just clean motor oil when installing. And , yes, I did put grease on the new distributor gear. Should I take the distributor out and wipe off the grease and put oil on the o-ring ? Thanks for an answer.
I have a 2010 Nissan Frontier 4.0 v6. It stalled on me in turn lane . The negative terminal was loose and I tightened it and it will crank but not start.
Was told the ecm was bad and needs to be replaced, can not locate the unit on a 2005 Nissian forester
Change battery need to find ac relay
Changed battery no ac and recirculating switch doesn't work
Water leak from top corners of rear glass
1998 Nissan. Frontier 2.4L
Get an estimate and never overpay again
RepairPal guarantees your repair will be done right.