Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Problem with clutch slave or master cylinder

(1990 Jeep Comanche)
in Lakeside, CA on January 10, 2011
i have a 1990 jeep comanche and am having problems with the clutch slave and/or master cylinder the symptoms seem to be that the clutch lines won't seem to keep pressure in them and fluid leaks out of the bell housing i continuously need to keep putting fluid in the master cylinder can anyone help me pinpoint this problem? and help me find a solution? any feed back on this would be immensely appreciated!
Displaying 1 answers & 0 comments
Popular Answer
on January 10, 2011
It sounds like the slave (actuator) sylinder on the other end of the line from the master cylinder is failing. You need to replace the slave and probably the master too at this point.
The transmission needs to come out to replace the slave cylinder. See a Jeep specialist or a transmission shop for help.
Here's a directory link for you:
http://repairpal.com/jeep-repair-in-lakeside-california
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Fuel pump relay burnt out and i put a new one but it has no power so car won’t start but if i run a hot wire over to ...
Suburban was running a little rougher than normal so i cleaned the throttle body. put it back on and now it is stumbl...
Didn't find what you were looking for?