Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Oxygen sensor

(1990 Jeep Wrangler)
in Victorville, CA on May 26, 2011
need to know how to remove and replace
Displaying 1 answer & 0 comments
Popular Answer
Most oxygen sensors are a 7/8" wrench, or a O2 sensor wrench. you just need to unplug the senor wire and remove as you would any other threaded nut or bolt. Lefty loosy, righty tighty. then plug the new one in, you may need to reset the code with a scan tool if it doesn't reset by itself. Local auto parts store will do that free, if you don't have one.
Sign in to reply
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Idle surge, engine light on, hard to start if cold and high humidity mornings, but starts right up if the temperature...
Hey guys i have no no damn clue how i even got here to ask a question so i'm going to use this for my my help and i'm...
Didn't find what you were looking for?