Close
Car Questions
RepairPal is your advocate for car care advice and guidance

No start ,Code reads po335, crankshaft position sensor was replaced with no luck

(2004 Chrysler 300M)
in Chester, IL on April 28, 2013
Checked incoming voltage, ok,checked sensor with analog volt meter while rotating engine by hand, checked out ok.Erased codes, tried several times, same results
Displaying 2 answers & 1 comments
Popular Answer
on April 29, 2013
Need a SCANNER to check crank sensor signal while cranking eng. Battery in good shape, cables clean and tight? Starter turning engine good and strong?
on June 04, 2015
Could u plz tell me where is the exact place of the crankshaft sensor on the engine ? 99 or 2004 Chrysler 300 m . I need to replace it and I couldn't find where is it located!?(if u know any photo or video about it, it is helpful too) thank u in advance for your help and time
on June 04, 2015
Could u plz tell me where is the exact place of the crankshaft sensor on the engine ? 99 or 2004 Chrysler 300 m . I need to replace it and I couldn't find where is it located!?(if u know any photo or video about it, it is helpful too) thank u in advance for your help and time
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Put bad gas in it one time bucked and jumped then died in the middle of the road. well put some cleaner for the gas i...
Didn't find what you were looking for?