I am pretty sure it is sending 12 volts to the pump but I just today found out which wire(s) to check at the relays. Could there be any other cause for my problem unless there is a short in yhe wiring which is doubtful due to the way the problem started out.
No Power To The Fuel Pump on 1995 Dodge Ram Van 2500
by T-man in Elizabethton, TN on August 17, 2009
ANSWER by dandd on August 22, 2009
You have to check this circuit while some is cranking the engine, or the computer will automatically shut of the power. Good Luck!
Our Van will not start and has no power to fuel pump we have bypassed the relay and the fuel pump came on the relays are good and so is the fuel shutoff switch on the firewall what else could it be.
I am not getting power to the fuel pump. I have checked the pump relays(2) on the firewall. Is there another cause for this problem? I do have 6-8 volts to the fuel gauge!
Im working on a 1997 dodge ram 2500 3.9L. The engine shuts off while driving or at idle like someone turned off the key switch. It will restart right away. I have replaced the following: Timing cha...
It Runs great for maybe 25 miles then loses power and will not pull up small grade. After It sits a few minutes. It will start running good for a little while then same story. It has new plugs,wire...
i have been trying to figure out what is causing this misfire code. less than year ago i did plugs, wires, rotor, cap. three months ago i had a misfire cylinder 6 code and it was a bad fuel injecto...