Close

1995 Mitsubishi 3000GT Questions

Get answers to your auto repair and car questions. Ask a mechanic for help and get back on the road.

Find questions for your car.
I bought this car from someone they said they replaced the clutch I found out the slave cylinder was leaking so I put a new one in it and proceeded to bleed the system it also has a new master cylinder for the clutch but it still will not go anywhere and it goes In all gears but it will not move the car will not move it will move if I Revit up real high it will move just a little
When the engine is cold it runs like a dream. When it gets up to temp it hesitates and backfires. Since I've had the car (about 9 months), all the timing stuff has been replaced, new plugs and wires, 3 new coil packs, new fuel filters, MAF and throttle thoroughly cleaned, new IAC, and has been checked for vacuum leaks. It also smells like it's running rich.

Any ideas?
i just had my timing belt and watrpump replaced now it has no powr it barely moves and backfires. it smells of gas also. when ignition is turned of after driving car its









mokes heavily and smells like wires burning? where do i start to try to figure out what is going on w it?
very hard for me to unlock it will a cylander in the starter help
do you think i need a new starter
was towed and did not have shake before it was towed
Car stalled after used engine, new clutch, new battery, new radiator, hoses, etc... put in. $3022.00 worth. The car tries to start, but won't. Had to tow. Now it starts, but repair shop says it will stall again. Does not show a diagnostic code. Now they say it could be the ignition module, or the crank sensor?? Does not know, for sure, says to replace both, and wants another $700.00. What if that doesn't fix it? I'm too far in financially already!
How do I remove the clutch for replacement?
major service maintenance 64000 miles recommended
Get an estimate and never overpay again
RepairPal guarantees your repair will be done right.