Close

1992 Mercedes-Benz 500E Problems

Find the most common issues based on 1992 Mercedes-Benz 500E owner complaints.
Tap theto learn more about the most common 1992 Mercedes-Benz 500E problems.

Most Common 1992 Mercedes-Benz 500E Problems

The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip t...
The electronic throttle assembly may suffer an electrical failure. It is often cheaper to send the valve to a service center for repair that to purchase a new part.
The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

Common 1992 Mercedes-Benz 500E Repair Estimates

Looking for a particular 1992 Mercedes-Benz 500E problem?

2 Known 1992 Mercedes-Benz 500E Brakes Problems

The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors. The brake rotor surfaces become uneven, causing a lip t...
As brake fluid becomes dirty over time, it can cause a failure of the anti-lock brake system (ABS) modulator assembly. Our technicians recommend a complete brake system flush every two years to hel...

4 Known 1992 Mercedes-Benz 500E Drive Train Problems

The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the...
Leaks may develop from the differential seals and/or cover on older or high mileage vehicles. Our technicians recommend a complete reseal of the differential unit when these leaks are addressed.

2 Known 1992 Mercedes-Benz 500E Electrical & Lights Problems

The electronic throttle assembly may suffer an electrical failure. It is often cheaper to send the valve to a service center for repair that to purchase a new part.
The engine wiring can degrade because the insulating material falls off leaving the bare wire exposed. This can cause many problems depending on which wires are exposed and what they touch.

5 Known 1992 Mercedes-Benz 500E Engine Problems

Internal and External engine oil & coolant leaks can develop from the head gasket and/or timing cover gasket; these leaks should be repaired before the engine oil and coolant intermix which can...
Oil feed tubes break and fall into the crankcase (engine) and the tappet becomes noisy (ticking), resulting in degraded idle quality. Our technicians recommend replacing all of the tubes at the sam...
A faulty mass air flow (MAF) sensor can cause erratic/rough engine operation and fuel economy issues. Since this sensor measures the actual amount of air entering the motor, when it fails, the engi...

1 Known 1992 Mercedes-Benz 500E Exhaust & Emissions Problem

Ports in the cylinder head related to the emissions air injection and EGR systems can clog; the cylinder head should be removed and the ports cleaned.

2 Known 1992 Mercedes-Benz 500E Heating & Air Conditioning Problems

Due to wear of mechanical parts in the control head, the buttons on temperature control assemblies work erratically or not at all. These control heads need to be replaced for this concern or when t...
One or more blend door vacuum actuators may fail resulting in the incorrect output temperature from the HVAC system. Failed actuators will require replacement to restore proper HVAC operation.

0 Known 1992 Mercedes-Benz 500E Maintenance Problems

6 Known 1992 Mercedes-Benz 500E Miscellaneous Problems

The seat springs and padding break down over time, causing a lean, tilt, or sag.
Due to wear of the internal drive gear, the speedometer can stop working.
The lenses for head lights may become opaque (cloudy or hazy) as a result of sun exposure. This can reduce the effectiveness of the lights. Our technicians tell us plastic polishes can improve ...

5 Known 1992 Mercedes-Benz 500E Suspension & Steering Problems

The tie rod ends, idler arm, and/or drag link components of the steering linkage may wear prematurely. Please keep in mind the wheel alignment should be checked and adjusted when any of these i...
The lower control arm bushings can wear and crack, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear problems. I some cases it may be necessary to ...
A worn steering dampening shock can cause a fluid leak at the front of the vehicle. If a leak is noted from the dampening shock, our technicians tell us that it should be replaced.

27
Known 1992 Mercedes-Benz 500E Problems & Complaints

The seat springs and padding break down over time, causing a lean, tilt, or sag.
The sunroof may not work correctly due to failed components as a result of age and wear. Repairing a sunroof can be labor intensive and very costly.
Due to age and sun exposure, the interior wood trim cracks and the finish gets a cloudy haze. Replacement if the trim would be the most common solution to the problem.
A knocking noise from the front end can be caused by cracked strut tower bushings.
Oil feed tubes break and fall into the crankcase (engine) and the tappet becomes noisy (ticking), resulting in degraded idle quality. Our technicians recommend replacing all of the tubes at the sam...
One or more blend door vacuum actuators may fail resulting in the incorrect output temperature from the HVAC system. Failed actuators will require replacement to restore proper HVAC operation.
Due to wear of mechanical parts in the control head, the buttons on temperature control assemblies work erratically or not at all. These control heads need to be replaced for this concern or when t...
A faulty mass air flow (MAF) sensor can cause erratic/rough engine operation and fuel economy issues. Since this sensor measures the actual amount of air entering the motor, when it fails, the engi...
Vehicles with automatic level control that ride harshly in the rear (no give in the suspension) may have one or both dampening actuators which have failed. It is commonly recommended the actuat...
The lenses for head lights may become opaque (cloudy or hazy) as a result of sun exposure. This can reduce the effectiveness of the lights. Our technicians tell us plastic polishes can improve ...
Internal and External engine oil & coolant leaks can develop from the head gasket and/or timing cover gasket; these leaks should be repaired before the engine oil and coolant intermix which can...
The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any ...
The electronic throttle assembly may suffer an electrical failure. It is often cheaper to send the valve to a service center for repair that to purchase a new part.
The engine wiring can degrade because the insulating material falls off leaving the bare wire exposed. This can cause many problems depending on which wires are exposed and what they touch.
A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
Researching a 1992 Mercedes-Benz 500E?
Get maintenance costs, reviews, recalls and more.