Close

1997 Mazda B4000 Questions

Get answers to your auto repair and car questions. Ask a mechanic for help and get back on the road.

Find questions for your car.
It wont go all the way in Park position.
Third brake light or cargo lights not coming on, fuse location?
There is a cigarette lighter and two 12v accessory sockets all fed by purple/blk wire with no power at any time, regardless of ignition switch position. Wiring diagram in Chilton and Haynes has no reference to fuse 17 (fuse tests good on ohmmeter).
Live data is showing a reading of 0.000 for all three O2 sensors, above and below. I am making the assumption that all 3 wouldn't fail or be bad. So it should be something upstream. Any help or direction in it what it could be or something more I can do? I have not replaced any of the O2 sensors as of yet. The P0133 and P0153 are causing the check engine light to come on.
when I turn on my air conditioner it shoots out freeon out like a pop off value on the pump why is that please help
Where can I get it,
My truck is a B2600
when you give it throttle it cuts out and dies ,when its cold it runs a little longer at idle and cuts out when throttling up and quits what is it ? MAF sensor? Thanks
Vehicle was working fine one minute, parked, turned off, tried to start again, would not crank and no starter noise. Battery is new and strong. Tried jiggling shifter for possible faulty neutral switch, but no help. Suspect the starter or solenoid. Is there any way of testing starter without taking it off and putting on a tester. While it is still on the vehicle? Please advise? Thank you. pat
The heater works fine. The a/c however only works in max a/c
setting as it blows quite cold. As soon as I set it down to normal
a/c setting with the dial still in the blue cold area.. it immediately
Begins to blow hot air. Not even the ambient temp. I just purchased
the 1997 B4000 4.0 two days ago and am still familiarizing myself
with it. My guess is a HVAC control module or door/flap? ? Ideas greatly
appreciated.. Thanks
where is this sensor located, could it be on the transmission ??











Rookie

after looking there are 2 cross members do they both have to be unbolted to disconnect clutch & pull trany, do you have any tips for this project do's & donts

Thanks,

CJ
after looking there are 2 cross members do they both have to be unbolted to disconnect clutch & pull trany, do you have any tips for this project do's & donts

Thanks,

CJ
On board diagnostic test failure. Computer stored trouble codes PO171 & PO174
Bank 1& 2 system too lean. Service engine light stays on and now it spits and sputters while driving
where can i find 1997 Mazda b 4000 ac fuse location.
Get an estimate and never overpay again
RepairPal guarantees your repair will be done right.