Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Just put a new slave cylinder in and it wont bleed up?i see no leaks anywhere...

(1998 Volkswagen Passat)
in Pittsburgh, PA on November 16, 2013
??????????????????????????????????
Displaying 2 answers & 0 comments
Popular Answer
of G. T. Service Center on November 16, 2013
Did you pre-bleed before you installed it? Now you probably have air in your master as well. Remove the slave and bleed the master and cap the line. Hold your slave vertical(with bleeder up), and fill cylinder with fluid, no air. Now reattach the line to the slave not allowing fluid to leak. Mount the slave, and pump the h-ll out of it.
on November 16, 2013
look for debris in the master cylinder blow out the lines if you have to and start over.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
When I stop at a light ,with my foot on the brake , the engine starts to race like it wants to take off
Didn't find what you were looking for?