Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Is it possible to tighten up the clutch cable and if so where can it be located?

(2000 Ford Explorer)
in Scranton, PA on March 07, 2011
Is it possible to tighten up the clutch cable and if so , Where can the adjustment screw be located?
Displaying 1 answers & 0 comments
Popular Answer
on March 07, 2011
This vehicle is equipped with a hydraulic clutch, there is no adjustment. If the clutch pedal is low, hen most probably the slave cylinder is faulty. Inspect the fluid level at the clutch master cylinder. It is the small reservouir near the brake master cylinder. There is a blck rubber boot under the cap that must be lifted out to see the level. If it is low, suspect a clutch slave cylinder which the trans must be removed for replacement.
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
When i crank up from cold start the a/c works fine for about 10 minutes then it blows hot and sometimes when it’s lef...
Did so, but still no power, could it be bad, was running fine, engine light started flashing, car started trying to...
Didn't find what you were looking for?