Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Installing a camshaft sensor

(2003 Ford Mustang)
in Waynesville, NC on October 04, 2009
Installed the camshaft sensor and it runs fine above 1500 rpm and really rough below. How do I adjust it?
Displaying 1 answers & 0 comments
Popular Answer
on October 09, 2009
There is special Cam Sensor alignment tool and with out it, it is very, very difficult. You can try to ever so slightly rotate the Cam Sensor while the car is idling. Remove the spout connector or octane connector and use a timing light to try and set base timing at 10 degrees when the car is warmed up and idling.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
harness. I need to run/control the engine/trany only. What do I need to do so?
Cylinder 2 has low compression pressure. Rework cylinder head to change valve seals and install new cylinder head gas...
Didn't find what you were looking for?