Car Questions
RepairPal is your advocate for car care advice and guidance

Idles fine,but wont take gas

(1997 Chevrolet S10)
in Elkview, WV on November 12, 2010
its 4.3 vortec with spyder injection, it will idle fine,but when I go to give it gas,it wont take it,it trys to quit.Its got a new fuel pump,new map senser,new mass air flow senser,new tps senser,new distributor,wires,plugs,new ignition module, Ican not figure it out,and i know a little bit about chevy,but this one has me puzzeled,can anyone give me some ideas? thanks......
Displaying 2 answers & 0 comments
Popular Answer
on November 12, 2010
is it fulding i have intake and spider
on November 12, 2010
i would double check you wires and make sure you put them in the right order, but other than that its prolly going to be timing control,electronic ignition mod may be wrong or you may just have a bad set of injecters
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
My car had a bad winter! I am disabled & rely heavely on it for transportation. When it is cold, the car started fine...
the motor starts right up, and at higher rpm;s seems fine. But if you take your foot off the gas it dies. wont idle a...
Didn't find what you were looking for?