Close
Car Questions
RepairPal is your advocate for car care advice and guidance

I replaced mastercylinder and clutch plate and throw out bearing now wontbleeed

(1990 Chevrolet S10)
in Lynnwood, WA on May 28, 2013
wont bleed resavore wont go down and when running makes wierd sound when engaging the clutch pedal
Displaying 1 answer & 0 comments
Popular Answer
of Greg's Orange Auto on May 29, 2013
you have to get the air out for proper operation. try having a friend help by pumping pedal for you,while you open bleeder. one person press on pedal to the floor while bleeder is open, close bleeder then have the person lift pedal by hand. repeat this until u get all fluid and no air
Sign in to reply
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
I have a 01 s10 4.3 vortec i have power from the coil to the distributor new cap and roter will not send fire to spar...
It starts and runs for just a few seconds then cuts off
Didn't find what you were looking for?