Close
Car Questions
RepairPal is your advocate for car care advice and guidance

I have a 1987 ford ranger and the cruse control won't work.

(1990 Ford Ranger)
in Ridgecrest, CA on March 04, 2015
The fuse is good and can't find any leaks.
Displaying 2 answers & 2 comments
Popular Answer
on May 11, 2015
make sure the vac switch dump valve is totally seated above brake light switch,check for vacuum leaks on that line
on May 16, 2015
That fixed it, thank you.
on May 17, 2015
glad to be of assistance
on March 05, 2015
Could be a bad cruise control switch or module. Not sure what would be leaking to not allow it to work.
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
All new plugs wire,s coil, used fuel pump good pressure,neutral park rev limit maybe 250,000 no oil use runs perfect ...
One of the vacuum lines has come unplugged. still attached to the vacuum ball (reservoir?). its the one on top (i kno...
Didn't find what you were looking for?