Close
Car Questions
RepairPal is your advocate for car care advice and guidance

I am trying to remove the front engine mount. I am replacing

(1997 Dodge Stratus)
in Fresno, CA on November 23, 2012
only the rubber inside part. how does the old one come out?????
Displaying 1 answers & 3 comments
Popular Answer
on November 23, 2012
if you are only replacing the rubber then you need to go to get it press out and then press back in
on November 23, 2012
this means the support arm from front of engine to back must be removed completely. the part in which the round housing supporting the new mount? at each end as a matter of fact. Correct? thx acely1
on November 23, 2012
why not replace the mount altogether it would be simpler
on November 23, 2012
I m sorry but when you say the mount all together, that would be the whole bar with front and rear mounts, (the round 3" to 4" cylinder type mounts.). I really didn't notice them to be seperated from
bar???
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Relatively new motor, new heater core, new water pump, new thermostat(x3). New blend doors (operational i checked) he...
I am trying to replace my drivers side lower control arm hut cannot access the bolt because the transmission/engine i...
Didn't find what you were looking for?