Close
Car Questions
RepairPal is your advocate for car care advice and guidance

HOW DO I SET TIMING BELT AND CAMS ON 3.5 V-6. ENGINE IS ASSEMBLED

(2003 Hyundai Santa Fe)
in Penn Valley, CA on September 02, 2012
TOOK HARMONIC BALANCER OFF, BUT CRANKSHAFT TIMING GEAR CAME OFF WITH IT. NOT SURE WHERE TDC IS. CAN I TURN CAMS AND CRANKSHAFT INDIVIDULY TO TIMING MARKS?
Displaying 1 answers & 1 comments
Popular Answer
on September 02, 2012
there is a mark on the crank gear. align only after setting the cams. otherwise you could bend a valve moving the cams into alignment

Roy
on September 03, 2012
THANKS. IS THAT FOR ANY INTERFERING ENGINE?
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
When you drive it, it's like you let off the gas, and then it will take off again, it will do this over and over. No ...
While accelerating to pass a car my 2001 Hyundai Santa Fe became sluggish and lost power. I pulled over and put it in...
Didn't find what you were looking for?