Car Questions
RepairPal is your advocate for car care advice and guidance

Hood release not working

(1990 Chevrolet Corvette)
in Tucson, AZ on March 30, 2011
I have a 1985 corvette, and the battery is dead. When I pulled the hood release, it only "popped" on the drivers side. This hasn't happened before. It doesn't seem as tho the cable is bad. Any suggestions?
Displaying 1 answers & 0 comments
Popular Answer
on March 30, 2011
I think these have a left and right hood latch/lock assembly #11 on this diagram and probably one of them is stuck So you might need someone to pull on the cable while you try and move the stuck side up and down until it releases. The parts are available at
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
After a small rust work on the rear door (trunk door) we notices a loose cable inside the rear door chassis. it is a ...
Had some moisture in sockets and outer surface. original bulbs appeared ok but replaced them anyway and removed all m...
Didn't find what you were looking for?