Close
Car Questions
RepairPal is your advocate for car care advice and guidance

High Brake Light for the convertible

(1990 BMW 325i)
in Loganville, GA on March 07, 2010
How do you change the high brake light on the convertible?
I can't figure out how to get into the housing.
Displaying 2 answers & 0 comments
Popular Answer
on June 29, 2010
It's a major pain. Must remove upholstery lining from trunk lid by prying out a dozen plastic fasteners and removing tool kit. This gives access (awkward) to four long screws with springs that hold light assembly in (8mm nuts). Without deep sockets, I had to use nedle-nose pliers and a lot of bad words. Light assembly is a mass of LEDs and a complex circuit-board loaded with electronics. Another example of the two-edged sword that is German engineering
Sign in to reply
on April 05, 2011
when you open your trunk you should see your tool box keep following down until you are directly under where the light is their are four phillip head screws unscrew those and your light should come out thats for a 1990 355ic convertable
Sign in to reply
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop
Video, Step-by-Step Instructions, Parts & Tools List
How to Fix Your Brakes

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
I my car is running fine after 128,000 miles. i have oil changed and fluids, belts checked every 4,000 miles or so. ...
Need help/advice toyota supra 1993 ge i'll keep the story short . blew head gasket and warped head, replaced both...
Didn't find what you were looking for?