RepairPal is your advocate for car care advice and guidance

Q: have a dtc 1106 and 1107 .baro pressure sesnor failure . where are they located, on 2002 Honda CR-V

was told the brs is internal in pcm
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
P1106 can be caused by a restriction in the air inlet--chek condition of air filter and related hose. P1107 is possible sensor circuit low voltage. reset PCM and see if it returns may be an intermittent issue. And also as stated before have honda check for any needed updates (emissions related updates from what I understand are only 8 years or 80K miles).Software update if available may not be free , but it may fix problem without replacing the PCM.
yes, you may wanna check your local honda dealer to see if you ecm has the lastes software installed, but more then likey it looks like you are going to need a ecm
Didn't find what you were looking for?