Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Have a 93 toyota 4 runner 3.0 cant get no fire out of coil or dist to plugs

(1993 Toyota 4Runner)
in Potwin, KS on January 13, 2013
i have checked the hot wire on coil and the ignition igniter module and still cant get fire
Displaying 1 answers & 2 comments
Popular Answer
on January 13, 2013
The ignition module may be bad.
on January 13, 2013
ant the ignition module the same as ignition igniter module if not were is the ignition module located at on the car
on January 13, 2013
I dont know the location of the ignition module. The computer tells the ignition module to fire the ignition coil and the coil sends spark to the distributor where the rotor inside ditributor sends the spark to the path of least resistance . This is usually the cyilinder that is to be fired unless there is something wrong with the cap or rotor. If you know the ignition module and ignition coil are good you may have a bad ignition switch. I have never hears of an ignition ignitor whatever that is.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Sometimes it shifts fine but mostly bad shifts from 1st to 2nd (hard shifts) I have checked everything lock up sylini...
It happens when check engine light is on.But check engine light gos off for a bit and then it works until it comes ba...
Didn't find what you were looking for?