Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Have a 2001 crysler town and country stated knocking after repair.

(2001 Chrysler Town & Country)
in Mobile, AL on February 24, 2014
I changed the lower intake , upper intake and valve cover gaskets. Also changed the plugs and plug wires along with the thermostat and hoses and water pump. Now when I crank it is hard to start and runs rough. Also it' sounds like a lifter it tapping. Sometime it quits and as you rev it up it starts back. Any suggestions I've checked all of the vacum lines, and check the plug wires to make sure there in there right location. Also when I pulled the injectors and fuel rail I replaced all orings
Displaying 2 answers & 2 comments
Popular Answer
on February 24, 2014
Foreign object in one of the cylinders from the repair.
on February 24, 2014
What would your next step be, pull it back down or pull plugs and inspect for contact
on February 24, 2014
Check the plugs for any sign of gap change. Bent tip. Bore scope would be very handy as well.
on February 24, 2014
Change the oil ,u must of got coolant in there when you changed the intake..
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Blown head gaskets..all replaced..new wires...plugs..coil pak..oil..oil filter..antifreeze...new battety..what could ...
I had a dead battery. Had it checked, Ok, needed charged slowly. Charged it and put it back in my 98 town & country. ...
Didn't find what you were looking for?