Close

1994 GMC Safari Problems

RepairPal has identified the most common problems with the 1994 GMC Safari based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
18
Known Problems

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

A fluid leak may develop from the transmission output shaft seal. This leak may cause the transmission mount to become oil soaked and require replacement of the mount along with the leak repair.

Power brake systems using "hydro-boost" may leak power steering fluid from the hydro-boost unit located behind the brake master cylinder. Replacement of the hydro-boost unit is the common repair to correct this concern.

An oil leak may develop from the distributor o-ring seal requiring replacement of the seal.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

Our technicians highly recommend that the transmission is serviced every 30,000 miles to avoid problems and maintain optimal operating order.

Brake fluid can become dirty and may cause problems in the brake system; it should be flushed every 60,000 miles.

The power door locks may stop working in one or more doors due to a failed actuator. Replacement of the failed actuator should correct this concern.

4.3L V6 multi-port FI only
The exhaust gas recirculation valve (EGR) may stick open causing a rough idle and the Check Engine Light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.

The fuel pump may fail causing the engine to stall and not restart. Our technicians recommend replacing the fuel filter every 30,000 miles to help prevent undue strain on the fuel pump.

A coolant leak may develop from the water pump. This can result in an engine overheating condition. A leaking water pump will require replacement.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.

The Anti-lock brake system (ABS) control unit may fail internally causing the ABS warning light to illuminate.

The outside door handles are prone to breaking—all doors are affected by this condition.

On vans with rear AC, the AC may stop blowing cold air due to a damaged AC line near the back of the engine. It is common for these lines to rub on the engine block, causing a hole in the line and a refrigerant leak.