Close
QUESTIONS

RepairPal is your advocate for car care advice and guidance

Q: Gears stuck and bad shifting on 1999 Chevrolet S10

10 months after re placing the clutch , pressure plate and thrust bearing , the gears shift is very sticky and sometimes stuck in 1st or R , could this be the slave cylinder that needs to be replaced and is that easy accessible?
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
| |
Normally if you had an issue with the clutch hydralic system it would affect shifting in all gears. replacing the slave cylinder is not too difficult but you will need to follow a bleed proceedure to remove the air from the system.
Thank you I will do so and let you know how things go
It worked a good bleed and a full reservoir , it's as good as new.
Didn't find what you were looking for?