Close

1992 Ford Ranger Problems

RepairPal has identified the most common problems with the 1992 Ford Ranger based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
7
Known Problems

The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.

If you experience cold starting problems, stalling at idle, or hesitations during acceleration, it may be the idle air bypass valve. This valve helps the vehicle idle steadily and run when the accelerator pedal is not pressed.

Bogging, hesitation or stalling may be experienced during moderate to heavy acceleration. This can be caused by a failing of many sensors or modules in the fuel injection system. It is recommended to have an experienced shop perform diagnosis to find the root of the problem.

The Ford Ranger V6 is known for a rough idle, engine stalling, loss of power, and misfires, accompanied by the check engine light.

The intake manifold O-ring gaskets commonly leak, which creates a large vacuum leak. This vacuum leak causes unmetered air to enter the engine, and the fuel system becomes insufficient to compensate for the large amount of air reaching the engine. 

Replacing the intake manifold gaskets corrects this concern.

The front brakes may stick, bind, or grab. This can happen when the front brake caliper pins become corroded. Cleaning or replacing the caliper pins will be necessary to correct this problem.

If a noise from the rear end is heard when going around turns or after driving at highway speed for an extended period, this could be caused by a failing deferential clutch kit. An updated differential clutch kit available.

The battery light may illuminate on the instrument panel because the alternator wire harness connector is damaged. A new connector kit is available and should be installed to correct this concern.