Close

2005 Ford E-250 Questions

Get answers to your auto repair and car questions. Ask a mechanic for help and get back on the road.

Find questions for your car.
The problem occurs mostly when I first take off
The vehicle will not shift out of park in to drive with or without the motor running
I already changed sparkplug all oxygen sensors and Cadillac converter and is not responding with power like it just to what else let need to look for?
The hood release behind the grill moves but the hood won't open.
I found an engine out a 2009 e250., just wouldering if this engine Will fit my 2005 e250 sharing the same w 8th digit bin number .. Please help
Ignition coil burns out after ten miles mil comes on and starta to missfires
Recently I had to change the battery. when I put the new one in there was this flashing light.
pedal fades while engine is running and brakes pull to the left upon hard braking ,replaced both front calipers too.could air be trapped in abs unit ? no codes on computer
bank ! sensor #2 high and low volts detected
every movable part was changed including rotors and bearings. could it be something in the steering shaft? feel it in steering wheel only no vibrating in front seats. i spent a lot of money on vehicle can`t give up on it...

Thank you
mr confused.


it starts in the afternoon when its hot outside.in the mornings it cranks but wont start
dealer gave me a code p0600 internal folt in pcm what does it mean ?
Was driving down the road and with no worning it was like the van went into nutral. Was able to drive it in drive but only shifts to 2nd and will only go a short disance in overdrive. Is it a sencer in the trany and how do I get to it? Thank you for your help.
how to take off the plastic cap on automatic trans shifter linkage to lube. manual suggests lubing every 6,000 mi.50,000 mi. on van & has never been done. should that effect the proformance after i finally lube? or do i need to replace that part? appreciate any help. steve
Get an estimate and never overpay again
RepairPal guarantees your repair will be done right.