Close

1999 Ford Crown Victoria Recalls

Get the latest 1999 Ford Crown Victoria recall updates.

Most Recent 1999 Ford Crown Victoria Recall

On January 7, 2004, Ford recalled 4,218 Ford Crown Victoria. On certain natural gas vehicles, if a flame from a vehicle interior fire becomes locally directed at the natural gas fuel tank located immediately behind the rear seat, the flame could damage the fiberglass wrap on the tank weakening the tank.
Not your car? Find your recalls now:

1999 Ford Crown Victoria Recall Details

Summary on January 7, 2004
On certain natural gas vehicles, if a flame from a vehicle interior fire becomes locally directed at the natural gas fuel tank located immediately behind the rear seat, the flame could damage the fiberglass wrap on the tank weakening the tank.
Summary on September 28, 2000
Vehicle description: passenger vehicles using aftermarket driver's seat belt assemblies that were sold by ford parts departments from january 1, through june 13, 2000. these seat belt assemblies fail to comply with the requirements of fmvss no. 209, "seat belt assemblies." the equipment involved is service stock seat belt assemblies, model nos. h 9977, h 9979, t 9063, and t 9217, built by trw vehicle safety systems, inc. (trw) manufactured from june 1, 1998 through may 21, 2000. some of these seat belt assemblies may have been installed as service replacement equipment on the vehicles involved in the recall.
Summary on September 28, 2000
Vehicle description: passenger vehicles using aftermarket front passenger side seat belt assemblies that were sold by ford parts departments from january 1, through june 13, 2000. these seat belt assemblies fail to comply with the requirements of fmvss no. 209, "seat belt assemblies." the equipment involved is service stock seat belt assemblies, model nos. h 9977, h 9979, t 9063, and t 9217, built by trw vehicle safety systems, inc. (trw) manufactured from june 1, 1998 through may 21, 2000. some of these seat belt assemblies may have been installed as service replacement equipment on the vehicles involved in the recall.
Summary on August 3, 2000
Vehicle description: passenger vehicles. these vehicles have jacking instructions which, if followed, could cause the vehicle operator to place the jack on a frame weld when attempting to raise a rear wheel. if the vehicle is jacked up with the jack placed on the frame weld and if the vehicle is free to roll (wheels not blocked or chocked), the jack could yield and the vehicle may drop suddenly.
Summary on January 18, 1999
Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. the one-piece bearing within the lower control arm ball joint can weaken slowly during use and eventually crack. this could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.
Get notified about future recalls
×
Page 1 Created with Sketch.
You're Signed Up!
We will notify you of any recalls that affect your
Close