Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Drive shaft of my Hyundai elantra 2003 model produces noise while curving.

(2003 Hyundai Elantra)
in Clinton, IA on August 02, 2013
while curving, bending or negotiating a curve or bend the drive shaft produces some noise . however the noise seizes after taking the bend or curving?
Displaying 1 answers & 0 comments
Popular Answer
on August 02, 2013
That is usually an indication of the CV axle halfshaft joint going bad. The way to test it is to slide under the car and push hard up and down on eack CV axle at the joints while listening for noise at the joint. The rubber boots that cover the joints will most likely be torn also. The fix is to have the CV axle halfshaft replaced.
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Why is it when my gas tank is about half full the engine will cut out. It runs great and no check engine light no co...
After the car cranks, it is rough putting the car into driver or reverse. For the first 3 miles the car transmission...
Didn't find what you were looking for?