Dodge Ram Van B350 Repair and Maintenance

A guide to problems, costs, maintenance and repair for your Dodge Ram Van B350

No_car_image
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
Get a Repair Estimate For Your Dodge Ram Van B350
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

Dodge Ram Van B350 Problems

HVAC Air Flow Switching to Defrost When Accelerating

The AC/heater (HVAC) system may unexpectedly switch to the defrost mode when accelerating. This system is operated by engine vacuum and should be inspected for any vacuum leaks if this problem develops.  There is also a revised vacuum check valve available to address this concern.

Erratic Blower Motor Operation Due to Overheated Switch

The blower motor may operate erratically and the blower switch operation has a sticky or mushy feeling, the detents almost non existent. Our technicians tell us that the blower switch should be removed and inspected for overheating. This is common if the blower motor is frequently operated on high speed as the current flow through the switch tends to melt internal the components. Also carefully inspect all of the switch connector terminals for discoloration due to overheating and replace as required. A poor electrical contact at the connector will also cause the switch to overheat.

Door Glass May Separate From Lift Channel

The door glass may separate from the glass lift channel. Our technicians tell us a front door glass channel kit is available to repair the door glass. The repair involves removing the door glass from the vehicle.

See More Problems (30)

Dodge Ram Van B350 Questions

Tranny rebuilt now on freeway it seems like its in 2nd instead of drive. Why (1 answer)

My van is a 1988 i had my automatic transmission rebuilt and now when im on the freeway it seems like its in 2nd instead of drive. its revving high and putting out alot more heat. They said its a three speed transmission and its fine. what else can cause it to rev like its in 2nd? it shifts 2 ti...

change fuel no voltage @plug (1 answer)

fuel pump will not start donot have any voltage @the pump. just install pump

I am getting no fire what the problem (1 answer)

See More Questions (64)