Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Cylinder position sensor

(1990 Honda CRX)
in Angle Inlet, MN on September 01, 2014
I was driving 90si
In the winter. And we got a cold snap nd i never drove it for a few days.
When i started it up next my idle was terrible and would just stall out. It ran perfect before.
My ecu has had some codes like o2 sensor. But i just had it replaced
Tps also had replaced before..
The biggest change in my ecu was it now shows the cylinder position sensor..
I have had it to the shop and they said my distributor was done and changed it.. But fixed nothing.. The said my computer was done. But i think they didnt want to get into it.
I have a air/fuel gauge and once warm runs so lean it doesnt register. Would that mean that my air is rich and gas is lean? If so could any lines have froze causing water in tank? Will putting gas line antifreeze in gas tank get that water out.. Completely stuck
This happened in march and still runs bad? Would any water have come out by now?
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
The engine fails to start it sometimes starts and fail other times 2005 Nissan Armada 5.6 I need the camshaft sensor ...
Turns over great but will not start. Checked for spark at cylinders#1&2 and determined it has no spark. Fuel pump com...
Didn't find what you were looking for?