Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Cylinder head torque sequence & torque specifications

(1990 Mercedes-Benz 300SE)
in Orangevale, CA on August 11, 2009
replacet head gasket
Displaying 4 answers & 1 comments
Popular Answer
on August 11, 2009
Cylinder head torque specs as follows.
Step 1. 41Ft. Lbs
Step 2. Angle Tighten 90 Degrees
Step 3. Angle Tighten 90 Degrees
Head torque sequence is from center of cylinder head outwards. It would be best to obtain a repair manual from your local Auto parts Store since Special procedure must be taken to inspect Cylinder Head Bolt measurement and procedure.
on December 16, 2010
what is the total ft lbs? is it 41ft. lbs each step?
on March 11, 2010
i need the head bolt torque spec for a 2000 lincoln navigator 5.4dohc
on February 01, 2010
i have a 2006 toyota camry, my timing belt broke and i was told the damage is internal how much csn i expect to pay for repairs
on March 04, 2010
chevrolet malibu 2001
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide. Learn more

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
I need the specifications on the torque settings on a 94 Nissan what to torque the head job on a 94 Nissan pickup
Replaced head gasket, flushed oil and water system. Checked daily everything ok. 5 days later oil level rose with wat...
Didn't find what you were looking for?