Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Control module

(1990 Honda Accord)
in Auburn, CA on May 09, 2011
How do you test the injector control module?
Displaying 1 answers & 0 comments
Popular Answer
The Honda ECU is pretty reliable on the Accord. To test the ECU you would need to test all the powers, ground and input signals to the ECU, then test the outputs. You need a wiring diagram to see what connections should have power, which should have ground, then you need an oscilloscope to look at sensor patterns. Autozone have some popular workshop manuals for free on line once you register (for free) on their website http://bit.ly/autozone_repair_info. There is also a company that independent auto repair shops buy their information from that the same information inexpensively to do it yourselfers. The information is year make and model specific repair procedures, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online
If you are pretty certain the ECU is bad, a company called Fuel Injection Corporation in Livermore CA can test the ECU for you if you send it to them, good people quick turn around.
2407 Research Drive
Livermore, CA 94550
Phone: 925-371-6551
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Trans locked in limp mode. usually could reset by putting in park and restart engine. it's been happening since purc...
As above.shop i usually use says it has to go to mb dealership due to propriatory code software related to a defectiv...
Didn't find what you were looking for?