Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Clutch

(1990 Mitsubishi Eclipse GSX)
in York, PA on March 19, 2011
i put everything new ,like a clutch cylinder,slave cylinder,master cylinder clutch but when im bleeding the clutch i open the valve and the pedal stay on the floor.what could be wrong?
Displaying 1 answers & 0 comments
Popular Answer
on March 20, 2011
I would fill clutch master cylinder, leave top off, raise vehicle and attach a hand held Mighty Vac to the bleeder at the slave cyl., pull fluid thru system till air is gone, make sure you check the clutch master cyl to be sure fluid stays full, if you have installed the clutch correctly then you should get a pedal. Are you sure you installed the clutch disc facing the correct way out.??
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
I installed a new clutch in my 93 prelude si it's a factory replacement powertorque from oriellys i bled slave all th...
Compressor clutch is engaging. gauge on the refrigerant can goes into the red.
Didn't find what you were looking for?