2000 Chevrolet Silverado 1500 Questions

Get answers to questions about your 2000 Chevrolet Silverado 1500 at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more

Code came up for fuel pressure regulator, so I replaced that, an autozone recommended changing fuel filter. Connections are pretty rusty, n I do not have flare wrenches. Could I just leave it n have a shop deal with it? I'd hate to twist or strip fittings.

No issues with the engine, just curious. I run Mobil 1 5w 30 that what previous owner used. Can I switch and still have quality oil?

Replaced resistor for blower motor, cause only highest setting worked. It worked fine after that, week later same problem. Now what ?

Service manual says for my model year resistor an relay are assembled together so entire unit gets replaced. How hard to do. What am I looking for? I'd like to buy correct fitting part before tearing everything apart

Blower did make noise on settings 1-4 so I assume it was ready to go anyway.

And it makes no difference weather the temperature selector is set to heat or ac

When I shift to reverse or drive and push accelerator there is a slight noise from rear end. Guessing u joints are bad. Do I need to replace all? Is it expenpsive? How difficult to do on my own

Had charging system tested battery tested "good" 12.59V 930CCA rated 770CCA temp was 65 degrees though. What about below zero temps an wind chill? Starter tested 11.22V 217.2Amps Charging test No load 14.74V Loaded 14.65V I would rather not replace battery if not needed

Just had a rebuilt tyranny installed.

Replaced fuel pump and still have same problem

I've had a problem with my dash cluster for some time now. I've checked every wiring harness for a draw and got nothing. I checked the cigar lighters and fuse, nothing. My cluster started to work today, so I test drove the truck. As I was going down the road the cluster started to go haywire. Flickering off and on until I came to a stop, then it worked fine again. Once I started to get going and pulled into my driveway, it stopped working completely. I had the cluster repaired, but don't think that that was ever the issue. I need some advice..

My dash cluster isn't working at all, and there's a draw on the battery. I plugged my code scanner into the port to see what it is, and the cluster starts working again, but there's no code. Once I disconnect the scanner the cluster does again. My 4wd indicator lights are all on and wot switch over as well.

Had a new ignition switch put in and now it throws security code 1681 I believe. It won't start. I've tried unhooking the battery and all the little tricks with the key.