Close
QUESTIONS

RepairPal is your advocate for car care advice and guidance

Q: can vehical learn passlock sensor data code from off to crank if done correctly? on 2005 Chevrolet Express 2500

Rookie cbe0621eac06868b3efe0d8d1d3611e23c60d3114864ea2ec19a68cfbd3eebab
My van started fine this cold day with in 5 min engine cutting in and out during warm up gages, lights flashed before stalled. tried to start engine cranked over and fired. Sat a few hours tried again in nuteral and ran strong till back in park and stalled again. tried reset, took off battery connections Neg & Pos hoped to reset computer codes? Brand new Fuel pump, plugs, wires, module, fresh gas replaced round 65,000 after using diesel fuel. ran good till today has K&N Air filter installed. Cranks but not will start or run
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
| |
30-MINUTE LEARN PROCEDURE
If your problem is related to a passlock issue it can be releared with this 30 min. procedure. IF that gets it going you may have a problem that may reoccure until you find the passlock problem. I have the relearn procedure listed below.

1.Turn ON the ignition, with the engine OFF.
2.Attempt to start the engine, then release the key to ON, vehicle will not start.
3.Observe the SECURITY telltale. After approximately 10 minutes , the telltale will turn OFF.
4.Turn OFF the ignition, and wait 5 seconds .
5.Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes . The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
6.Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password.
IMPORTANT: The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.



Didn't find what you were looking for?