Close

Buick Regal Recalls

Get the latest Buick Regal recall updates.

Most Recent Buick Regal Recall

On May 4, 2001, Buick recalled 116,007 Buick Regal. Vehicle description: certain passenger vehicles, equipped with sunvisor located air bag labels, fail to conform to federal motor vehicles safety standard no. 208, "occupant crash protection." these vehicles have a message area less than 30 cm which does not meet the requirements of the standard.
Not your car? Find your recalls now:

Buick Regal Recall Details

RepairPal Expert Overview on May 4, 2001
Vehicle description: certain passenger vehicles, equipped with sunvisor located air bag labels, fail to conform to federal motor vehicles safety standard no. 208, "occupant crash protection." these vehicles have a message area less than 30 cm which does not meet the requirements of the standard.
Summary on December 29, 2000
Vehicle description: passenger vehicles. corrosion of the air bag inflator's internal wiring, which can occur over time, could cause the inadvertent deployment of the driver's air bag. this deployment could occur during vehicle start-up, while the vehicle is parked or idling, or while in operation.
RepairPal Expert Overview on November 16, 2000
Vehicle description: passenger vehicles. some of these vehicles exhibit a condition in which the driver side impact air bag inflator separates from the air bag module during deployment.
Summary on September 28, 2000
Vehicle description: passenger vehicles originally sold or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, where road salt use is heavy. a condition where one or both front engine cradle bolts can pull through the retainers due to corrosion of the retainers.
RepairPal Expert Overview on August 24, 2000
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. the buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."