Close

2002 Buick Regal Questions

Get answers to your auto repair and car questions. Ask a mechanic for help and get back on the road.

Find questions for your car.
When adding power steering fluid 2 my 2002 Buick Regal do I leave the engine running
I think I need to replace the pump but not sure what that would cost
2002 BUICK REGAL GS Supercharged: Solid Security light and solid Check Engine Light lit for over a year with the engine running fine before scanning. I scanned all systems with Blue Driver OBD2 Diagnostic Scan Tool while the engine was running. Scan revealed confirmed codes P0102 and B2958. It also displayed historical Security codes B2960, B2957 and B2961. I selected "Clear All Codes" and then the engine died. I attempted to restart the vehicle but the vehicle only clicked, no crank, no start. I attempted the GM Passlock relearn procedure but it did not work. No crank, no start and the solid Security light, Check Engine light still remain. I scanned the system again and current Security code B2958 and historical Security code B2960 are the only codes that remain. Battery is fully charged. Can a scan tool really cause a vehicle not to start? How do I fix this?
2002 Buick regal car just cuts off randomly and then it won't start back. I changed the spark plugs and wires, crank shaft sensor, harness to the crankshaft sensor, fuel filter, air filter, and got a new battery. Timing belt is good, alt is good, and the fuel pump was changed last year and just checked. The car is getting gas. What else could it be??? Is there a kill switch on this car? Please help me.
I have a 2002 Buick regal and recently I was driving and my car just cut off. I took it to the shop and they replaced my crankshaft sensor. It drove fine for a week and cut off again. Took it back and everything has been replaced to figure out the problem. Changed spark plugs and wires, fuel filter, air filter,battery, crank shaft wire hornest. My starter, timing belt, and alt are all good.My car will start fine until it cuts off and then its hard to start back up. The car sounds like it wants to turn over. No one can figure out this problem. Is there a Kill switch in this car?? What could this problem be please someone help me. Its been 1 month of trying to figure it out and replacing things and keeping the same problem. Could it be a bad connection somewhere, blown fuse? Oh and my fuel line was checked and the car is getting gas, the fuel pump was just replaced last year. Please someone help me
Antilock,Trac,Service Veh. Lights On.
Do you have to take the motor mounts loose
The security light has come (back) on. Local mechanic replaced the ignition lock cylinder when the light previously came on. Since then the key will not go fully into the off position and cannot remove the key. I have tried using graphite which gives temporary relief but this is an everyday issue.
location to add fluid
STEPS TO INSTALL A NEW TDM ON A BUICK WITH NEW KEY
WHEN A NEW PASSKEY IS MADE WITH THE OLD RESITOR VALUE AND A NEW TDM INSTALLED HOW DO WE MATCH THEM UP
Get an estimate and never overpay again
RepairPal guarantees your repair will be done right.