Close
Car Questions
RepairPal is your advocate for car care advice and guidance

Brake job!

(1990 Mercedes-Benz 300CE)
in Austin, TX on October 16, 2010
Hi,

I replaced my pad on my car last night and tried to bleed the brake but nothing happens. After replacing the front pads I tried again. Now my brake pedal just goes to the floor. How do I get fluid back in the system? Did I miss a step?
Displaying 1 answers & 0 comments
Popular Answer
of Auburn Foreign & Domestic on October 20, 2010
If the pads are installed inmproperly they may be sitting to far from the brake rotor- try "pumping" the system up 5- 10 times 1st- if that does not fix it check the pad installation!! Good luck,Greg
Get a repair estimate
RepairPal estimates are guaranteed at over 2,000 quality certified locations nationwide.
Or interested in getting a repair? Find a Shop

Similar Questions

View answers to similar questions from RepairPal's community of auto experts and enthusiasts.
Our 2010 sienna le 2wd has recently developed a "fluttering" noise (a little softer than a clatter) that sounds like ...
Didn't find what you were looking for?